Product description
This water alarm immediately stops the water supply as soon as leakage occurs. At the same time, the mains voltage is switched off at the outlet.
Pumps, machines, leaking hoses or loose couplings can cause a lot of water damage. Tip: the water-detection cable sensor (see picture), with a length of 1.5 m, ensures extra fast reaction.
Applications
With this plug & play set, complete with all electrical connections and cables, you achieve leakage protection. Tip: also handy when you are away: pull out the plug to block the water supply.
Water valve secures pump or machine
You mount the voltage-controlled water valve in the supply pipe. It operates on pre-pressure from the water supply pipe. The valve is available in various diameters (see options) and can be installed horizontally or vertically.
Interrupts mains voltage in case of leakage
Plug the control cable of the valve into the socket on the front of the water alarm.
Via a junction box, you can also connect other 230-volt devices, such as a pump, to it. These are then automatically switched off in the event of a water alarm.
Only when both detection pins of the sensor are wet at the same time will the alarm unit switch off the 230-volt power supply. As a result, the valve (valve) no longer receives voltage and the water supply stops. (This is also the case when the mains voltage fails)
Mounting the water sensor
The standard water sensor is connected to the alarm unit via a 10 m cable. You place this sensor on the floor, under the appliance to be protected or where leakage may occur. The sensor may be mounted horizontally or vertically.
The water alarm set consists of:
- Electronic water alarm
- Water sensor (see options)
- Brass water valve
- Connector + control cable (not shown)
*Please note that a basic knowledge of electrical engineering is required (for installation) when purchasing some products on our webshop.
