Float switch | plastic
Simple float switch in plastic version, for tap water, rainwater, waste water and similar liquids.
The mounting height determines the switching point of the float. Calculated from the bottom, a water level of at least 1 cm is required before the switch contact responds.
Switch contact for NO or NC
Rising water will cause the float to float and activate its built-in switch contact. Applicable for detecting a maximum or a minimum level.
You can turn the float body (the float) to set the switching function to NC (normally closed) or NO (normally open). Warning: this float is not suitable for switching mains voltage.
Connect to water detector
The float sensor can be connected to a water detector or level control instead of a conduction sensor. The 2-wire signal line may be extended up to 50 m.
Float PP - technical data
- Type: Waterproof Float
- Mounting: vertical only
- Material: PP (polypropylene)
- Working temperature: -10...+85 °C
- Switch contact: NO or NC
- Switching power: < 50 W
- Switching voltage: < 200 Vdc
- Length: total approx. 10 cm
- Float/ float: Ø 26 mm
- Free stroke: 17mm up-down
- Connecting wires: 2x 40 cm
- Fixing: nut M10
- Weight: approx. 20 g