Temperature switch TS-1000

This temperature switch has a 230 V output for temperature-controlled control of a pump, electric heater or other device.
The external temperature sensor, in flexible industrial design with waterproof casing, can measure the temperature even under water.
The LED light shows whether the heater (or other connected device) is switched on.

Memory for all settings

This temperature switch can also be used as a digital thermometer, for monitoring and reading the temperature.
The highest and lowest temperatures measured are stored in memory. If the mains voltage is disconnected, the set temperatures remain in memory.
This temperature switch has an attractive housing with a clear red LED display, and is intended for wall mounting indoors.

Temperature sensor 2 or 10 m connecting cable

Note: only suitable for Pt1000 type sensors. A matching temperature sensor is available in 2 lengths, see selection bar. Or click for other Pt1000 sensors.
If the sensor cable is interrupted or short-circuited, a fault message appears. The connection is 2-wire and this can easily be extended to 50 m with normal signal cable or cord.

Temperature switch PT1000 - specification

•    Measuring range: -99...+850 °C
•    Connected load: 3,000 W
•    Output: 16 A changeover contact
•    Connection voltage: 230 V
•    Power cable length: approx. 1.6 m
•    Power consumption: approx. 2 W
•    Operation: via 3 push buttons
•    Dimensions: 180x80x60 mm
•    Sensor type: Pt1000 (2-wire)
•    Screw connector: 2-pole
•    Connection cable: see selection bar
•    LED display: red, 12.7 mm
•    Indicator lights: 3x LED
•    Safety class: IP20
•    EN manual: yes
•    Quality mark: CE